![]() The 90-degree alignment provides a solid nailer at every 16″ for fastening the boards perpendicular to the rafters. Tip: If you’re able, cutting all the boards the same size keeps things consistent and allows you to set up a cutting jig for faster, more efficient cutting. Once we knew that measurement, we snapped a chalk line across the top of the ceiling slope as a visual reference. We took the 1/2 inch off the largest measurement and cut all the sloped ceiling boards the same size. We decided to use a super highly technical carpentry trick called “splitting the difference” (just kidding). We first installed 1×3 strapping 16″ on center over the ceiling rafters. In a perfect world these two measurements would be the same, but they were off by 1 inch. We measured from the top of the roof down to the LVL on both ends of the porch. This 90-degree alignment provides a nailer at every 16 in. In order to accommodate the pattern, we first had to install 1×3 strapping at 16 inches on center so we could install and fasten the beadboard. The beauty of beadboard is its versatility, which is only limited by the user’s ideas. The wanted the boards to run parallel to the roof rafters, not perpendicular. We recently built a screen porch for a client who wanted a beadboard ceiling, but they wanted the orientation of the boards to be different than most ceilings they’ve seen. Historically, beadboard was a durable, basic wall or ceiling finish that was common by the 1880s and was also popular in cottages, camps and unheated buildings. Alternative Heating & Fireplace Inserts. ![]()
0 Comments
Leave a Reply. |